Computer Mounting Take 2
Monday, May 10, 2004 at 01:30AM I bought a cheap case which wasn't as tall so i could fit it under the shelf in the back of my trunk. The case was only $17 dollars but it's pretty flimsy. Also, the powersupply is mounted over the cpu so i'm kind of concerned about cooling.
Here is a picture of my current configuration:
All i did was cut out a slot in a milk crate for my case to fit in and to keep it moving forward it's secured with a bungee cord. I am using this as a temporary mounting.
I fabricated the mounting below pretty quickly out of some scrap wood i found laying around at home. Unfortunently it it a little to tall. It was a last second decision to mount it onto the base board for more structural support. Had i just used some right angle brackets on the side pieces and then screwed it directly into my carpet it would of just barely fit. The reason i mounted it to the baseboard was because i didn't have short enough screws to screw the right angle brackets into the wood. Next time i go home from college i'm gonna make something more permanent.
(Note: Images are a little stretched)
Reader Comments (1)